EquiFit ImpacTeq Peel Away Replacement Liners for D-Teq & Eq-Teq & Pro2 Series Front Boots

Large

$105.00

EquiFit ImpacTeq Peel Away Replacement Liners for D-Teq & Eq-Teq & Pro2 Series Front Boots

$105.00

Size Large Medium Small Extra Large

EquiFit Front Boot Size Guide

Measuring your horse's front ankle circumference is the most accurate way to size EquiFit boots. If your horse is between sizes, the ankle circumference measurement takes priority over height.

Size	Horse Type	Height (hands)	Ankle Circumference
Small	Large Pony	14.0–14.3	10"–10.75"
Medium	Small Horse	15.0–15.3	10.75"–11.5"
Large	Standard	16.0–16.3	11.5"–12.25"
Extra Large	Oversize	17+	12.25"–13.25"
XX-Large	Oversize+	17+	13.25"–14.25"

How to measure the ankle
Wrap a soft measuring tape around the narrowest part of the fetlock (ankle) joint, just above the point where the leg meets the hoof. Keep the tape snug but not tight, and level all the way around. Measure both front legs and use the larger reading.

Between sizes? Choose by ankle circumference first — a boot that fits the ankle protects the joint correctly. Height is a guide only.

Sizing notes: Measurements shown are EquiFit's published front-boot ranges. This chart covers front boots and front-boot replacement liners. Pony-size boots (e.g. MultiTeq, Pony Medal) run smaller than Small. On EquiFit's own chart the XX-Large row is labelled “Extra Extra Large.”

EquiFit ImpacTeq® Peel Away Replacement Liners are designed to refresh compatible front boots without replacing the full boot. Made for D-Teq, Eq-Teq, and Pro2 Series front boots, they help maintain the fit, feel, and protective support of the original boot system.

This is a compatibility-driven product. Before ordering, confirm your boot model, front orientation, and size so the replacement liner matches the boot you are refreshing.

Best for

Refreshing worn liners in compatible EquiFit front boots
Fine-tuning fit with peel-away layers
Maintaining the fit and function of an existing EquiFit boot system

Key features

ImpacTeq® Peel Away liner — replacement liner with a peel-away layer to fine-tune the fit.
Made for specific boots — fits EquiFit D-Teq, Eq-Teq, and Pro2 Series front boots.
Replacement-part value — extend the usable life of compatible boots by replacing the liner rather than the whole boot.

Fit, compatibility & care

Fit: Match the liner size to the size of the compatible front boot, then peel layers as needed for a precise fit.
Compatibility: Fits EquiFit D-Teq, Eq-Teq, and Pro2 Series front boots. Don’t interchange front and hind liners.
Care: Remove liners from the boots before cleaning. Brush off dirt and hair after use, clean per EquiFit’s care guidance for the liner material, and allow liners to dry fully before reinserting.